Ships USA-wide
Wakol D 3540 cork adhesive, gallon pack.
Overview
Solvent free, water based contact adhesive for the interior installation cork tiles with natural cork backing on porous and non-porous subfloors, walls and to permanently adhered, non-cushioned, clean, existing floor coverings. Apply adhesive to floor and back of tile. Please use a roller for application.
Water Based contact adhesive with Zero VOCs. Wakol D3540 Cork Adhesive can be used for interior installation of cork tiles and underlayment over porous and non-porous substrates.
Acceptable Substrates:
- Plywood (at or above grade)
- Concrete (at or above grade)
- Drywall (unfinished)
- Painted drywall so long as the paint has been covered in latex/water based primer
Special Features: - Elongated working time
- High initial bonding strength
- Fast curing (24 hrs)
***Liquids such as Water Based Contact Adhesive and Polyurethane are NON-REFUNDABLE PURCHASES. NO credit will be given for liquids returned to us.
Shipping
Attention Clients: Please be aware there are special requirements when shipping/purchasing cork glue down tiles and the liquids during winter months.
These liquids are temperature sensitive and will become defective if exposed to temperatures below 5 Celsius (40F). Separate shipping may be required (and separate shipping costs apply). Transit times requiring more than 5 days could be subject to separate shipping at and could possibly require shipping in the Spring.
| VOC Content | Zero | Clean Up | Soap and water before adhesive dries |
| Applicator | Loba roller # 60 – 80 or # 120 Microfibre Roller 10mm (3/8”) |
Coverage per Gallon | 170 – 180 sf of laid cork tile (this takes into account the need to coat both the cork and the substrate) |
| Work Site Conditions | Normal Indoor Living Conditions required: 60 °F to 75 °F, 40% to 65% relative humidity | Airing time | 30 – 45 min, depending on climate conditions and absorbency of substrates. Allow adhesive to flash completely (dry) until it is clear |
| Open time | 2 to 3 hours when cork and substrate are being coated at the same time Tiles can be precoated as much as 24 hours in advance. When installing precoated tiles the working time is reduced to 1 to 1.5 hours |
Curing time | Curing takes 24 hours |
| Base | Synthetic polymers and latex | Manufacturer | Wakol Germany |
Flooring
Wall & Ceiling Tiles
Cork Underlayment
Supplies & Guides
Kelly P. (verified owner) –
Bought this with the tiles for the kitchen. Tack time is honest, gives you time to position and still grabs. Backordered a week so the job slipped.
Carol P. (verified owner) –
Ordered this alongside the flooring for the shop. Coverage matched what the label says, one jug did the shop. Cleaned up with warm water before it set, no drama.
Maia V. (verified owner) –
Bought this with the tiles for the sunroom. Low odour for a contact cement, we stayed in the house. Would buy again for the next room.